X55 Series - I/P and P/I Converters
Model X55-600 Series - Current to Pressure Transducer
 | Selectable input current ranges of 4-20 mA or 10-50 mA |
| Output pressure ranges of 3-15 psig, 3-27 psig, or 6-30 psig |
| Selectable direct or reverse acting modes |
| Can be mounted in any position |
| Vibration resistant |
| Low air consumption |
| Selectable split ranging in direct or reverse acting modes |
| Output air flow booster |
| Operating temperature range from - 40 to 140 F |
| Intrinsically Safe Rated |
| GP, NEMA 4, or NEMA 7 housings |
Ronan's new state of the art X55-600 Series ACCUTRANS I to P transducer features field selectable input current ranges of 4-20 mA and 10-50 mA for standard output pressures of 3-15 psig, 3-27 psig and 6-30 psig. Utilizing advanced solid-state technology, the ACCUTRANS provides high reliability and exceptional output accuracy over a wide temperature range. The unit features minimal vibration sensitivity (less than +/- 1% of span at 1.0 g from 5 to 2000 Hz) and can be mounted in any directional position. The ACCUTRANS incorporates a volume booster with up to 3 SCFM and can be operated at supply pressures between the upper pressure output plus 5 psig to a maximum of 120 psig. These small compact units are available in a variety of case configurations to match any environmental or hazardous area requirement.
Model X55-300 Series - Pressure-to-Current Converters
Ronan's Series X55-300 P to I converts instrument air pressures to analog current or voltage signals. The two and four-wire models are both available with five common input ranges from 3-15 psig to 0-100 psig. A solid-state sensor assures you of outstanding linearity, negligible hysteresis, very fast response times, and excellent temperature stability.
The electronics portion of our P to I Converter can be removed from the pneumatic base without loss of air pressure. This means you can perform simple calibration and regular maintenance without purging the air lines. Simple to install and maintain, the X55-300 features output monitoring test jacks, a loss-of-air alarm, an adjustable setpoint alarm option, and front access calibration.
Ronan's Series X55-300 P to I Converters provide standard current and voltage signals to instruments and process control computers. Non-standard signal formats are also possible; thereby, eliminating costly interface design requirements for special applications.